Znyx Networks bh5700 用户手册
zspconfig
NAME
zspconfig - configure and start surviving partner
SYNOPSIS
zspconfig [-d <level>] [-p <directory_path>] [-u
<dhcp_interface>] [-c <dhclient.conf>] [-t <timeout>] [-s]
[-v] -f <file>
[-v] -f <file>
DESCRIPTION
zspconfig is used to configure and start the Surviving Partner software. With the -f
option a configuration file is provided that completely describes the network setup and
desired behavior of all of the switches participating in the Surviving Partner. With the -u
option the interface on which to run dhclient to retrieve a configuration file must be
provided. The configuration file format retrieved by a -u is identical to that supplied with
-f. It is envisioned that the -f option is used for initial configuration, and all subordinate
and replacement switches run zspconfig with the -u option. The -v option prints the
current version of zspconfig and performs no actions.
desired behavior of all of the switches participating in the Surviving Partner. With the -u
option the interface on which to run dhclient to retrieve a configuration file must be
provided. The configuration file format retrieved by a -u is identical to that supplied with
-f. It is envisioned that the -f option is used for initial configuration, and all subordinate
and replacement switches run zspconfig with the -u option. The -v option prints the
current version of zspconfig and performs no actions.
OPTIONS
-d <level> Set the debug level. The default debug level is 1.
The higher the level, the more debugging output is produced.
Debugging output is sent to the console.
Debugging output is sent to the console.
-p <directory_path>
Set the directory path for where zspconfig places the scripts
it generates. The default location is
it generates. The default location is
/etc/rcZ.d/surviving_partner.
-u < dhcp_interface>
Come up as an unconfigured slave. Use the specified
Come up as an unconfigured slave. Use the specified
<dhcp_interface> to retrieve the configuration. User
confirmation is not required unless the –s option is also
confirmation is not required unless the –s option is also
used.
-c <dhclient.conf>
Use file <dhclient.conf> as the configuration file to dhclient
Use file <dhclient.conf> as the configuration file to dhclient
when retrieving configuration information. If –c is not used,
a default configuration file is created and used. Only valid
a default configuration file is created and used. Only valid
with the –u option.
Ethernet Switch Blade User's Guide
release 3.2.2j
page 246