Znyx Networks bh5700 Manuale Utente

zspconfig - configure and start surviving partner

zspconfig [-d <level>] [-p <directory_path>] [-u 

<dhcp_interface>] [-c <dhclient.conf>] [-t <timeout>] [-s] 
[-v] -f <file>

zspconfig is used to configure and start the Surviving Partner software.  With the -f 

option a configuration file is provided that completely describes the network setup and 
desired behavior of all of the switches participating in the Surviving Partner.  With the -u 
option the interface on which to run dhclient to retrieve a configuration file must be 
provided.  The configuration file format retrieved by a -u is identical to that supplied with 
-f.  It is envisioned that the -f option is used for initial configuration, and all subordinate 
and replacement switches run zspconfig with the -u option.  The -v option prints the 
current version of zspconfig and performs no actions.  

-d <level> Set the debug level.  The default debug level is 1. 

The higher the level, the more debugging output is produced. 
Debugging output is sent to the console.

-p <directory_path>

Set the directory path for where zspconfig places the scripts 
it generates.  The default location is 

/etc/rcZ.d/surviving_partner.

-u < dhcp_interface>
Come up as an unconfigured slave. Use the specified 

<dhcp_interface> to retrieve the configuration. User 
confirmation is not required unless the –s option is also 

used.

-c <dhclient.conf> 
Use file <dhclient.conf> as the configuration file to dhclient 

when retrieving configuration information. If  –c is not used, 
a default configuration file is created and used. Only valid 

with the –u option.

Ethernet Switch Blade User's Guide

release  3.2.2j

page  246