Zeiss Axiovert 100 操作指南

3D Microscopy

Eyepiece version

Axiovert 100/135/135 M

18

B  40-022-4  e    09/98

1

Eyepieces with 3D shutter

2

3D-CONTROL DSA-3

3

Line connection

4

3D illumination shutter

1

Fuse compartment

2

Voltage selector

3

Holding unit

4

Window

Fig. 3

Changing the voltage selector on rear of
3D-CONTROL DSA-3

 Set up the microscope in accordance with

the operating instructions of the Axiovert
100/135/135 M

 Equip the microscope with LD condenser

0.55 Ph1, Ph2, Ph3, DIC, DIC

 Connect the components for 3D microscopy

to the 3D-CONTROL DSA-3 control unit: Fig.
2
 Connect eyepieces with 3D shutter to the

EYEPIECE sockets

 Connect 3D illumination shutter to the

ILLUMINATION SHUTTER socket

 Connection to the line:

 

Prior to connection to the line,

check wether the voltage set on the
selector at the rear of the 3D-
CONTROL DSA-3 unit complies with
the line voltage; it may be necessary to
change from 230 V to 115 V or vice
versa:

Fig. 3

 Pull the power plug before changing the

fuses or the voltage

 Use a small screwdriver to press out the

clamping piece of the fuse holder at the rear
of the 3D-CONTROL DSA-3 unit; lift the fuse
holder out of the fuse compartment

 Remove the fuses
 Pull voltage selector out of its holder
 Turn voltage selector around 180° and insert

it back in its holder:
the new voltage is visible in the window

 Insert the fuses listed under Technical Data
 Insert fuse holder back in the fuse

compartment until click-stop