Utica Boilers SFE IV Steam 安装指导

Electrical wiring must conform with the latest revisions of 

the National Electrical Code, ANSI/NFPA No. 70, and/or 

local authority having jurisdiction.

When an external electrical source is utilized, the 

boiler, when installed, MUST BE electrically grounded 

in accordance with these requirements.

Install a fused disconnect switch between boiler and 

meter at a convenient location.

When the boiler is equipped with self-energized 

controls, no outside source of electric power shall be 

connected to the circuit of this system. (See "Steam 

Thermostat should be installed on inside wall about 

four feet above floor.

NEVER install thermostat on outside wall.

Do not install thermostat where it will be affected by 

drafts, hot or cold pipes, sunlight, lighting fixtures, 

television, fireplaces, or chimneys.

Check thermostat operation by raising and lowering 

thermostat as required to start and stop burner.

Instructions for final adjustment of thermostat 

are packaged with thermostat (adjusting heating 

anticipator, calibration, etc.).

Electrical shock hazard.  Turn OFF electrical power 

supply at service panel before making electrical  

connections.  Failure to do so could result in death 

or serious injury.