Utica Boilers JE 安装指导

Electrically bond boiler to ground in accordance with       

requirements of authority having jurisdiction.  Refer to 

National Electrical Code, ANSI/NFPA 70.

Install fused disconnect switch between boiler and 

electrical panel in convenient location. 

Secure wiring from high temperature limit control to boiler 

jacket or gas piping to prevent accidental disconnect from 

controls.

Tape all wiring to gas valves securely to gas supply lines 

or run in appropriate conduit.

Follow instructions included with your thermostat. 

Locate thermostat about 5 feet above floor on inside wall. 

Keep thermostat(s) at desired room temperature. 

If windows are opened or heat is not needed, set 

thermostat(s) to lower setting.

Set heat anticipator setting per thermostat 

manufacture instructions.

Follow thermostat manufacture instructions for final 

adjustment.

When set above temperature indicated on 

thermometer, boiler burners should ignite. Verify 

thermostat(s) turns boiler off when room temperature 

reaches selected setting and starts boiler when room 

temperature falls few degrees.

Set thermostat for desired temperature. 

Behind Doors 
Corners and Alcoves

Concealed Pipes  
Fireplaces  
TV Sets  
Lamps  
Direct Sunlight  
Kitchens

Concealed Pipes or Ducts 
Stairwells
Drafts 
Unheated Rooms on other side of Wall

Label all wires prior to disconnection when servicing 

controls.  Wiring errors can cause improper and 

dangerous operation. 

  

Electrical shock hazard.  Turn OFF electrical power 

supply at service panel before making any line 

voltage connections.  Failure to do so could result 

in death or serious injury.