XiNCOM X16-R 用户手册

下载
页码 82
 
 
Page 9 
2: Basic Setup 
Overview 
Basic Setup of your MULTI-WAN GATEWAY involves the following steps: 
1.  Attach the MULTI-WAN GATEWAY to a PC using any LAN port (3 to16) and configure it for your 
LAN. 
2.  Install your MULTI-WAN GATEWAY in your LAN and connect the Broadband Modem(s). 
3.  Configure your MULTI-WAN GATEWAY for Internet Access. 
4.  Configure PCs on your LAN to use the MULTI-WAN GATEWAY. 
Requirements 
•  One (1) up to eight (8) DSL or Cable modems, each with an ISP Internet Access account. 
•  Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors 
•  TCP/IP network protocol must be installed on all PCs. 
Procedure 
1: Configuring the MULTI-WAN GATEWAY for your LAN 
1.  Use a standard LAN cable to connect your PC to any LAN port (3 -16) on the MULTI-WAN 
GATEWAY. (Default is 2 WAN ports from Port 1 – 2) 
2.  Connect the power cord into the power outlet on the rear panel of the MULTI-WAN GATEWAY.  
3.  Power-on your PC. If your PC is already running, restart it. It will then obtain an IP address from 
the MULTI-WAN GATEWAY. 
4.  Open your WEB browser. 
5. In 
the 
Address or Location box enter: 
HTTP://192.168.1.1 
6.  You will be prompted for the User Name and password, as shown below: 
 
Figure 2-1: Password Dialog