RoboteQ Dual Channel Digital Motor Controller AX500 用户手册
AX500 Motor Controller User’s Manual
17
Powering On the Controller
This wiring - with the wire loop uncut - assumes that the R/C radio will be powered by the
AX500 controller. Other wiring options are described in “R/C Operation” on page 81 of the
User’s Manual.
AX500 controller. Other wiring options are described in “R/C Operation” on page 81 of the
User’s Manual.
Important Warning
Do not connect a battery to the radio when the wire loop is uncut. The RC battery
voltage will flow directly into the controller and cause permanent damage if its volt-
age is higher than 5.5V.
voltage will flow directly into the controller and cause permanent damage if its volt-
age is higher than 5.5V.
Connecting the optional channel 3 will enable you to turn on and off the accessory output.
See “Connecting Sensors and Actuators to Input/Outputs” on page 47 and “Data Logging
in R/C Mode” on page 91 of the User’s Manual.
See “Connecting Sensors and Actuators to Input/Outputs” on page 47 and “Data Logging
in R/C Mode” on page 91 of the User’s Manual.
Powering On the Controller
Important reminder: There is no On-Off switch on the controller. You must insert a switch
on the controller’s power terminal as described in section“Connecting to the Batteries and
Motors” on page 15.
on the controller’s power terminal as described in section“Connecting to the Batteries and
Motors” on page 15.
To power the controller, center the joystick and trims on the R/C transmitter. In Analog
mode, center the command potentiomenter or joystick.Then turn on the switch that you
have placed on the on the VCon wire.
mode, center the command potentiomenter or joystick.Then turn on the switch that you
have placed on the on the VCon wire.
8
9
15
Pin 1
Channel 1
Wire loop bringing power from
controller to RC radio
controller to RC radio
Channel 2
3:
Channel 1 Command Pulses
4:
Channel 2 Command Pulses
6:
Radio battery (-) Ground
7: Radio
battery
(+)
8:
Channel 3 Command Pulses
Channel 3
FIGURE 4. R/C connector wiring for 3 channels and battery elimination (BEC)