RF-Link Technology NL6000 用户手册
RF Neulink
NL6000 User Guide
36
initiate the download at this time, press ESC. There is a delay while the
system erases the flash to prepare for the download.
system erases the flash to prepare for the download.
4.
When the system prompts you to send the DSP build, initiate the
download from the terminal emulator.
•
If you use Procomm, use the Send ASCII Text option.
•
If you use HyperTerminal, use the Send Text File option.
A message appears with the estimated download time. The estimate
is based upon the time it takes using Procomm. If you use
HyperTerminal, the download may take longer.
is based upon the time it takes using Procomm. If you use
HyperTerminal, the download may take longer.
A countdown message shows the progress of the download. A
success message appears when the download is complete.
success message appears when the download is complete.
5.
When the download is complete, cycle power to reset the modem.
This causes the modem to use the new software build.
This causes the modem to use the new software build.
6.
Press ESC to continue using the Main Menu.
Saving Parameters to Disk
If you want to duplicate parameter values on several NL6000 units, you can
save the settings to disk and restore them to multiple units. Use the following
procedure to save parameter values from the unit currently attached to the
serial port.
save the settings to disk and restore them to multiple units. Use the following
procedure to save parameter values from the unit currently attached to the
serial port.
1.
Select Save/Restore Parameters
ä Save Parameters to Disk.
2.
Using Procomm or HyperTerminal, open the file where you want to save
the parameters.
the parameters.
3.
Press Y to confirm that you want to save parameters. If you do not want
to save parameters at this time, press ESC.
to save parameters at this time, press ESC.
4.
Wait until the output to the terminal emulator stops. You will see a
checksum at the end.
5.
Stop the text capture function on the terminal emulator and close the file.
6.
Press ESC to continue using the Save/Restore Parameters menu.
Restoring Parameters from Disk
If you want to duplicate parameter values on several NL6000 units, you can
save the settings to disk and restore them to multiple units. Use the following
procedure to restore saved parameter settings to the unit currently attached to
the serial port.
save the settings to disk and restore them to multiple units. Use the following
procedure to restore saved parameter settings to the unit currently attached to
the serial port.
1.
Select Save/Restore Parameters
ä Restore Parameters from Disk.
2.
Using Procomm or HyperTerminal, open the file that holds the parameter
settings.
settings.
3.
Press Y to confirm that you want to restore parameters. If you do not want