Panasonic Attune II 操作指南
22
Specification
• Speaker
Sound pressure level:
Sound pressure level:
90 dB (1 W, 1 m {3.28 feet}, Typical)
Impedance: 8
Ω
Frequency response:
250 Hz to 15000 Hz (–10dB, Typical)
Power capacity:
5 W (RMS*
1
)
• Microphone
Sensitivity:
Sensitivity:
–52 dB (0 dB=1 V/Pa, 1 kHz, Typical)
Frequency response:
100 Hz - 6000 Hz (–10 dB, Typical)
• Miscellaneous
Input/Output:
Input/Output:
Stranded cables, connector is attached to the end.
Cables
Approximately 2700 mm {106-5/16
inches} two core shielded wire
Inner sheath color: Red: +
Black: –
Gray: GND
Gray: GND
Connector
Euro type 3P connector
Operating temperature:
–20 °C to +50 °C {–4 °F to 122 °F}
Dimensions:
114 mm x 114 mm x 70 mm
{4-1/2 inches (W) x 4-1/2 inches (H) x 2-3/4 inches (D)}
{4-1/2 inches (W) x 4-1/2 inches (H) x 2-3/4 inches (D)}
(Excluding
projections)
Weight:
Approximately 1.0 k
g {2.2 lbs.} (without bracket)
Approximately 1.2 k
g {2.6 lbs.} (with brackets)
Finish: Plastic-molded,
black
*1 Rated noise power specified by IEC60268-5:2003+A1:2007(E), International Electrotechnical
Commission (IEC).
Dimensions and weight indicated are approximate.
Specifications are subject to change without notice.
Specifications are subject to change without notice.
Standard accessories
Operating Instructions (this document) ............................................................................ 1 pc.
Bracket ......................................................................................................................... 2 pcs.
Screw for installation (M5 × 15) ..................................................................................... 2 pcs.
Wind screen ................................................................................................................... 1 pc.
Gaskets for front panel and bracket ................................................................................ 1 set
Foam1, Foam2 for installation ..................................... Provided as part of packaging material
Plug connector for installation
(Already inserted into the socket connector of the main unit) ........................................ 1 pc.
Screw for installation (M5 × 15) ..................................................................................... 2 pcs.
Wind screen ................................................................................................................... 1 pc.
Gaskets for front panel and bracket ................................................................................ 1 set
Foam1, Foam2 for installation ..................................... Provided as part of packaging material
Plug connector for installation
(Already inserted into the socket connector of the main unit) ........................................ 1 pc.