TANDBERG CODIAN 2200 用户手册

 

81 

To configure monitoring using SNMP, go to 

. 

The IP VCR sends out an SNMP trap when the device is shut down or started up. The SMNP page allows you to set 
various parameters; when you are satisfied with the settings, click 

.  

Note that:  

• 

The 'system up time' that appears in the trap is the time since SNMP was initialized on the IP VCR (and 
therefore will differ from the Up time reported by the IP VCR on the 

 > 

 page). 

• 

The SNMP MIBs are read-only. 

Identifies the IP VCR in the SNMP system MIB. 

Usually you would give every device a unique 
name. The default setting is: 
Codian IP VCR  

The location that appears in the system MIB. 

An optional field. It is useful where you have more 
than one IP VCR to identify where the unit is 
located. The default setting is: 
Unknown 

The contact details that appear in the system MIB.  An optional field. The default setting is: 

Unknown 

Add the administrator’s email address or name to 
identify who to contact when there is a problem 
with the device. If SNMP is enabled for a port on 
the public network, take care with the details you 
provide here. 

A description that appears in the system MIB. 

An optional field, by default this will indicate the 
model number of the unit. Can be used to provide 
more information on the IP VCR.  

Select this check box to enable the IP VCR to send 
traps. 

If you do not check this box, no traps will be sent. 

Select this check box to enable authentication 
failure traps. 

You cannot select this check box unless you have 
selected to Enable traps above. Authentication 
failure traps are generated and sent to the trap 
receivers when someone tries to read or write a 
MIB value with an incorrect community string.