TANDBERG Telepresence T3 用户手册

119078.01 TELEPRESENCE T3 SYSTEM ASSEMBLY 12.08

TANDBERG

Telepresence T3

While holding the Cable well, thread the audio, VGA and ethernet cables into 
the opening of the well. Fasten the cables with the cable clamp so that appr. 

80cm of the cables are left outside.

Sink the cable wells onto the premounted screws. Fasten the screws and 
close the lid. If the lid is not flush with the table top, loosen the screws and 

adjust the cable wells. Then fasten the screws again.

and onwards for details on the cabling.

 The power cable supplied 

with the system is terminated with a 
standard IEC connector. An approved 
cable with a country-specific connector 
will be supplied later. If you source 
such cables locally, make sure they are 
approved!