Omron SYSMAC C200HW-ZW3AT2-E-V2 用户手册

“K: Check” is used to check the routing tables for errors or inconsistencies. If er-
rors are detected, correct the routing tables as described in Error Messages (on
page 92).

Note “K: Check” checks the routing tables in the computer memory. To check the rout-

ing tables that have been set at a node, use “T: Transfer” on the Routing Table
Menu to read the tables to the computer, then execute “K: Check.”

1. Select “K: Check” from the Routing Table Menu. The routing table check will

start and the check results screen will be displayed.

A message will be displayed in the lower part of the screen according to the
check results as follows:

When no error has been detected: “Check OK” 
When errors are continued on the next page: “Continue” 
When the current screen is the last page: “Last page”

2. When errors are displayed on multiple screens, use the F4 (Pre Pg) Key, the

F5 (Nxt Pg) Key, the Page Up Key, or the Page Down Key to switch the
screen and display the check results. After confirming the check results,
press the F10 (End) Key.