Omron SYSMAC C200HW-ZW3AT2-E-V2 用户手册

The following tables list the error messages that are displayed on the check re-
sults screen. After confirming the check results, use “E: Edit” to correct the rout-
ing tables, then check them again.

•

Too many networks

The number of networks set
in the table is outside the
allowable range (0 to 16).

Data may have been
damaged.

Initialize the routing tables,
then set them again.

Local netwk addr err

The network address
specified in the “Loc Netwk”
column is outside the
allowable range (1 to 127).

Change the network address
to a value between 1 and
127.

SIOU unit No. range
err

The unit number is outside
the allowable range (0 to
15).

Change the unit number to a
value between 0 and 15.

Dup local netwk addr

The same local network
address is specified more
than once.

Change the local network
address to a unique address.

Dup SIOU unit No.
err

The same unit number is
specified more than once.

Change the unit number to a
unique number.

•

Too many networks

The number of networks set
in the table is outside the
allowable range (0 to 20).

Data may have been
damaged.

Initialize the routing tables,
then set them again.

End netwk addr
range err

The end network address is
outside the allowable range
(1 to 127).

Change the network address
to a value between 1 and
127.

Relay netwk addr rng
err

The relay network address is
outside the allowable range
(1 to 127).

Change the network address
to a value between 1 and
127.

Relay node addr rng
err

The relay node address is
outside the allowable range
(1 to 126).

Change the network address
to a value between 1 and
126.

Dup end netwk addr

The same end network
address is specified more
than once.

Change the local network
address to a unique address.

Relay netwk addr err

A network address not in the
local network table is
specified as a relay network
address.

Specify one of the network
addresses set in the local
network table.