Omron SYSMAC C200HW-ZW3AT2-E-V2 用户手册
5-10
Section
S: Display Node Status
110
The following information is displayed.
Item
Meaning
Data link (DataLnk)
Displays the data link operation status.
Error message
(Error msg)
(Error msg)
Displays the setting error status.
Error: o
No error:–
No error:–
Communications
controller error
(Com controller err)
controller error
(Com controller err)
Displays the error status of the communications controller of
the Controller Link Unit or Controller Link Support Board.
the Controller Link Unit or Controller Link Support Board.
Error: o
No error:–
No error:–
Backup status
Displays the error information recorded in the Controller
Link Unit or Controller Link Support Board.
Link Unit or Controller Link Support Board.
Error: o
No error:–
No error:–
Logging status
Displays the presence or absence of the error log in the
Controller Link Unit or Controller Link Support Board.
Controller Link Unit or Controller Link Support Board.
Error log exists:
Y
No error log exists:
N
Setting information
(see note 1)
(see note 1)
Displays the terminating resistor setting status, baud rate
setting status, and external power supply status of the
Controller Link Unit or Controller Link Support Board.
setting status, and external power supply status of the
Controller Link Unit or Controller Link Support Board.
Terminating resistor switch (for CS1W-CLK21-E only)
ON (with terminating resistor):ON
OFF (without terminating resistor): OFF
ON (with terminating resistor):ON
OFF (without terminating resistor): OFF
Baud rate (bps) (for CS1W-CLK21-E only)
2 Mbps:
2 Mbps:
2M
1 Mbps:
1M
500 kbps:
500K
Power supply status (for optical type only)
Power is supplied:
Power is supplied:
Y
Power is not supplied:
N
Note
1) Setting information is displayed only when the status of the following nodes
is read.
•
Controller Link Unit for CS1-series PCs: CS1W-CLK21 (wired)
•
Controller Link Unit for CS1-series PCs: CS1W-CLK11 (optical)
•
Controller Link Unit for CS1-series PCs: CS1W-CLK12 (optical ring)
•
Controller Link Support Board for IBM PC/AT or compatible computers:
3G8F5-CLK11-E (optical)
3G8F5-CLK11-E (optical)
2) The “Display Node status” function can be used only for the Controller Link
Network. If networks other than Controller Link are specified, the node sta-
tus will not be displayed normally.
tus will not be displayed normally.
1, 2, 3...
1. Select “S: Display Node status” from the Main Menu.
2. Specify the target node. Use the Cursor Keys to move the cursor to the de-
sired field, then enter a numeric value with Numeric Keys. (Use Alphanu-
meric Keys to enter a PC ID.)
meric Keys to enter a PC ID.)