Omron SYSMAC C200HW-ZW3AT2-E-V2 用户手册
145
Appendix A
Error Messages
Error message
Cause
Action to be taken
1st page
The displayed screen is the first screen.
There are no more screens before this
screen.
screen.
A required file could not be
found. Please reinstall.
found. Please reinstall.
The required file has not been installed
or damaged.
or damaged.
Reinstall the file.
Address range err
The specified bit or word address is
incorrect.
incorrect.
Check the PC model and specify the
correct address.
correct address.
Cannot join network
The local node is not participating in the
network.
network.
Check the node participation status of
the network.
the network.
Can
’
t write
The specified area is read-only.
Check the specified area.
Comm err
Communications were not executed
normally.
normally.
Check the communications cables.
DataLink active – can
’
t run
Cannot be executed because the data
links are active.
links are active.
After stopping the data link, execute
again.
again.
DataLink internal setting
The data links are set to automatic
setting.
setting.
Set the data link to optional setting.
DataLink stopped – can
’
t run
Cannot be executed because the data
links are inactive.
links are inactive.
After starting the data link, execute
again.
again.
DataLink table err – can
’
t run
Cannot be executed because the data
link table has not been registered.
link table has not been registered.
Register the data link table.
Drive device err
The specified drive does not exist.
The floppy disk has not been formatted.
Check the drive name of the data disk,
memory card, or hard disk.
memory card, or hard disk.
Format the floppy disk before saving the
file.
file.
Echoback comm err
The network has communications
problems.
problems.
Check the network.
EEPROM error
Data in the EEPROM in the Controller
Link Unit or Controller Link Support
Board is damaged.
Link Unit or Controller Link Support
Board is damaged.
Reset the data link tables, network
parameters, and routing tables.
parameters, and routing tables.
Executing – Can
’
t run
PC is in monitor or run mode.
Change the PC mode to program mode.
FAT is destroyed
The floppy disk, memory card, or hard
disk is corrupted.
disk is corrupted.
Replace the floppy disk, memory card, or
hard disk.
hard disk.
File access error
The floppy disk file cannot be read or
written.
written.
Re-create the data to be read or written.
File does not exist
The specified file does not exist on the
specified data disk, memory card, or
hard disk.
specified data disk, memory card, or
hard disk.
Press the F8 (Files) Key to display the
file name list, and check the file name.
file name list, and check the file name.
File error
The floppy disk, memory card, or hard
disk has an error.
disk has an error.
Use a new floppy disk, memory card, or
hard disk after formatting them.
hard disk after formatting them.
Floppy not loaded
No floppy disk, memory card, or hard
disk exists in the specified drive.
disk exists in the specified drive.
Insert a floppy disk or memory card in
the specified drive or check the specified
drive name.
the specified drive or check the specified
drive name.
Insuff disk capacity
The data disk, memory card, or hard disk
capacity is insufficient.
capacity is insufficient.
Prepare another floppy disk or memory
card.
card.
Invalid table
The data link table has not been set
correctly.
correctly.
Set the data link table correctly.
Last page
The displayed screen is the last page.
There are no more screens after this
page.
page.
Network does not exist
The specified network does not exist.
Check the specified network address
and specify the correct network address.
and specify the correct network address.