Omron SYSMAC C200HW-ZW3AT2-E-V2 用户手册
Appendix A
Error Messages
147
Error message
Action to be taken
Cause
Send time-out
A transmission wait timeout error has
occurred.
occurred.
Increase the maximum node response
time and execute again.
time and execute again.
That name exists
The same file name exists on the data
disk, memory card, or hard disk. English
characters are not case-sensitive (for
example, LAN and lan are recognized as
the same name).
disk, memory card, or hard disk. English
characters are not case-sensitive (for
example, LAN and lan are recognized as
the same name).
Specify another file name or save the file
on another data disk, memory card, or
hard disk (directory).
on another data disk, memory card, or
hard disk (directory).
Unable to start due to insufficient
memory capacity. Processing
stopped. Press any key.
memory capacity. Processing
stopped. Press any key.
The amount of free memory space is
insufficient.
insufficient.
Check the amount of free memory space
and review the values set in FILES and
other parameters in CONFIG.SYS.
and review the values set in FILES and
other parameters in CONFIG.SYS.
Write protected
The data disk is write-protected (the hole
in the corner of the disk is uncovered).
in the corner of the disk is uncovered).
Always use the data disk in
write-enabled state (with the hole
covered).
write-enabled state (with the hole
covered).
Wrong drive
The specified drive name is incorrect.
Check the drive name of the data disk,
memory card, or hard disk.
memory card, or hard disk.
Wrong file name
The specified file name is incorrect.
Check the file name including the
extension, then specify the correct file
name.
extension, then specify the correct file
name.
Wrong key
The entered data is wrong.
Enter the correct data.
An invalid key was pressed.
Press the correct key.
Wrong netwk number
The number of networks specified in the
routing table is incorrect.
routing table is incorrect.
Specify the correct number of networks.
Wrong network type
The specified network is not Controller
Link.
Link.
If the Controller Link Support Software is
running under Windows 95, there are too
many active applications running in the
background.
running under Windows 95, there are too
many active applications running in the
background.
The specified network is not Controller
Link.
Link.
If the Controller Link Support Software is
running under Windows 95, there are too
many active applications in background
mode.
running under Windows 95, there are too
many active applications in background
mode.
Wrong path
The specified path name is incorrect.
The data drive name specified in
“
Data
dsk drv
”
of the System Setup is
incorrect.
Check the path name of the data disk,
memory card, or hard disk.
memory card, or hard disk.
Wrong position
The cursor is in the wrong position.
Move the cursor to the correct position.
Wrong setting
The entered data is incorrect.
Enter the correct data.