KVH Industries TracVisionM7 用户手册

11

In Step 6, you routed the RF coax cable(s) from 
the antenna, through the cable access hole, and 
into the vessel. Follow these steps to connect the 
RF coax cable(s) to the customer’s satellite TV 
receiver(s).

a. If you are connecting two receivers to the 

TracVision system, decide which receiver 

will be the primary receiver. The primary 

receiver controls satellite selection.

b. Connect the RF1 cable from the antenna to 

the “Satellite In” jack on the primary receiver 

c. If you are connecting two receivers, connect 

the RF2 cable from the antenna to the 
“Satellite In” jack on the secondary receiver.

d. Connect the receiver(s) to the customer’s 

television(s). Follow the instructions in the 

receiver’s manual.

If you wish to connect three or more receivers 

to the antenna, see Appendix A on page 21.

Antenna

Secondary Receiver - Optional

Primary Receiver

This receiver controls
satellite selection

RF1

RF2

Figure 19:  Wiring the Receivers to the Antenna

Be sure all receivers are grounded. If the 

receiver has a 2-prong power plug, run a 

ground wire from the receiver’s chassis to a 

suitable ground point. If a potential exists 

between AC and DC grounds, connect the 

wire to the switchplate’s DC return instead.

Wire the Receiver(s)

9