KVH Industries TracVisionM7 用户手册

Before you begin, consider the following
switchplate installation guidelines:

• Select a switchplate mounting location in a

dry, well-ventilated area belowdecks away

from any heat sources or salt spray.

• Be sure to leave enough room at the

switchplate’s rear panel for connecting the

dimensions).

• Since the supplied data cable is 50 ft (15 m)

long, the switchplate must be located within

50 ft (15 m) of the antenna.

Prepare the Switchplate Mounting Site

Once you have identified a suitable switchplate
mounting site, follow these steps to prepare the
site for installation.

a. Using the switchplate mounting template

provided at the end of this manual, mark and

cut out a hole in the mounting surface to

accommodate the switchplate (see Figure 7).

b. Using the same template, mark the locations

for the four switchplate mounting holes.

c. Drill a 3/32" (2.25 mm) hole at the four

mounting hole locations. Later, you will

mount the switchplate using four #6 screws.

2.96"

(75.2 mm)

4.39"

(111.5 mm)

Figure 6: Switchplate Dimensions

3/32" ( 2.25 mm)
Mounting Hole (x4)

3.82"

(97 mm)

.32" (8 mm)

2.36"

(60 mm)

.16" (4 mm)

3.19"

(81 mm)

2.05"

(52 mm)

Panel Cutout

Figure 7: Switchplate Mounting Holes Layout

Plan the Switchplate Installation