KVH Industries TracVision M5 用户手册

29

Follow these steps to turn on the system and set it 
up for one of the three European Trisat groups:

1. Ensure the antenna has a clear, unobstructed 

view of the sky.

2. Apply power to the receiver(s), TV(s), and 

switchplate. Wait two minutes for startup. 

3. Press the center MENU button on the MCP to 

access the onscreen menu (see Figure 47).

4. At “Install Satellite?”, press YES.

5. At “Trisat Mode?”, press YES.

6. At “USA or Europe?”, press EUROPE.

7. At “Install Europe WB?”, press NEXT until 

the display shows the Trisat group you want 

to select. Then press YES.

8. At “Set Lat/Long?”, press YES.

9. At “Latitude”, use the - and + buttons to set 

each digit of the vessel’s latitude. Press Enter 

to accept each digit.

10. At “Longitude”, set the vessel’s longitude. 

11. At “Trisat skew angle”, note the reported 

skew angle for future reference. Be sure to set 

the LNB to this skew angle later.

12. Set up the receiver(s) for the same satellites, 

and in the same order, as the antenna:

Europe WB 

HotbirdWB, Astra1, Astra2S

Europe 

Hotbird, Astra1, Astra2S

Scandinavia

HotbirdWB, Sirius, Thor

Sat. A

Alternative 1 or A

DiSEqC 1

Sat. B

Alternative 2 or B

DiSEqC 2

Sat. C

Alternative 3 or C

DiSEqC 3

Use +/- to set vessel latitude

Use +/- to set vessel longitude

Press NEXT until desired Trisat group shown

Figure 47:  European Trisat Group Selection Menus on MCP

Selecting a Trisat Group 

(Linear only)

C

Appendix