Motorola GT10 用户手册

GT10/GT30

9.1

What to Do If Something Unusual Occurs (GT10)

137

1) The power voltage may be low.
2) The contrast is set too low.
3) The backlight is off due to the [Back-

light Auto–off] setting in the [Setup] of

the GT10 configuration settings in

GTWIN.

1) Supply 24V DC 0.3 A.
2) Bring up the system menu and adjust

the contrast.

3) Touching any area of the screen lights

that area. If a switch part is set on the

touched area, the area will not light

even if touched. To change the setting,

change the content of the backlight

auto–off settings.

The backlight auto–off timer setting is too

short.

Change the backlight auto–off timer set-

ting.

1) The GT10 internal clock is incorrect.
2) Clock data is lost when power is off

because the secondary battery is not

set to ON.

3) The secondary battery is set to ON

but due to long periods with the power

off or on (over 10 days), the clock data

has been lost.

4) The PLC’s internal calendar timer

used as a reference is incorrect.

1) Bring up the system menu and adjust

the clock.

2) Turn off the power, and after turning on

the No. 1 operation mode setting

switch on the back of the GT10, power

up the unit and adjust the clock.

3) Turn on the power and set the system

menu clock data. In cases when pow-

er is off for approx. 10 days, it takes

around 2 hours for the secondary bat-

tery to fully charge.

4) Adjust by rewriting the value in the

PLC’s internal calendar timer.

All PLC

manuals

1) Hold PLC Device data is being lost

when power is turned off because sec-

ondary battery is not set to ON.

2) The secondary battery is set to ON,

but due to long periods of power off or

on (over 10 days), the Hold PLC De-

vice data is being lost.

1) Turn off power, and after turning on the

No. 1 operation mode setting switch

on the back of the GT10, re–supply

power to the unit.

2) Turn on the power and use the unit. In

cases when power is off for approx. 10

days, it takes around 2 hours for the

secondary battery to fully charge.

1) The switch part size setting does not

match the touch panel grid.

2) Valid conditions have been set for the

switch part, but those conditions have

not been met. (Applies only to custom

parts.)

1) When creating screens with GTWIN,

match grid settings to touch panel and

make them valid, then resize.

2) Check that the device status condi-

tions on the PLC side are valid.

GTWIN HELP

GTWIN HELP

1) The [Switch Sounds] setting under

[Options] in the switch part attributes

is set to [Disabled].

2) The [Touch Sounds] setting under

[Setup] in the GT10 configuration set-

tings in GTWIN is set to [Disabled].

1) Change the setting to [Enabled].
2) Change the setting to [Enabled].

GTWIN HELP
page 82

Bit F of the first word in the basic com-

munication area bit device is set to ON.

Set the F bit to OFF on the PLC side.

(Do not use the basic communication

area with ladder programs.)

Bits A and B, and Bit D, of the first word

(backlight color setting) in the basic com-

munication area bit device are set to ON.

Or, Bits C and D (backlight flashing set-

ting) are set to ON.

Perform correct bit operations on the

PLC side. (Do not use the basic commu-

nication area with ladder programs.)