Husqvarna Grinder SG13B 用户手册

SET-UP

16 - 

HUSQVARNA

Set the brake rod assembly into the brake bracket. 

7. 

The brake rod assembly needs to be adjusted 

before connecting the yoke to the brake. Turning 

the yoke clockwise shortens the rod, tightening 

the grip on the brake disc by the brake pads. 

Counterclockwise loosens the clamping force.
After adjustment, attach the yoke to the brake’s 

8. 

top mounting hole using the clevis pin and cotter 

pin.
Turn the adjustment nut against the spring and 

9. 

washer until the spring set snugly against the 

brake bracket and has a small amount of tension. 

With proper brake adjustment, the wheel will slide, 

but not turn, when the handle is over center.  

To engage brake, pull back on the handle until 

brake rod assembly goes “over center” and locks 

the brake ON. Test for proper tension and grip.

Remove  air  cleaner  and  double  wire  clamp  from 

10. 

engine.

CLAMP

THREAD WIRE HARNESS

AND THROTTLE CABLE

GUIDE

CLEVIS PIN

HAIR PIN

Route the wire harness from engine and the throttle 

11. 

cable through guide and handle crossmember.
Connect  upper  and  lower  wire  harness  together, 

12. 

yellow to yellow—black to black.

ADJUSTMENT NUT

BRAKE BRACKET