Husqvarna Grinder SG13B 用户手册
SET-UP
HUSQVARNA
-17
THROTTLE
CABLE
ENGINE
THROTTLE
CONTROL LEVER
FORWARD
THROTTLE
CABLE
Push throttle control lever on console forward to
13.
full extent. Pull throttle control lever on engine
back as far as possible. Insert “L” end of throttle
cable into the outside hole of the engine throttle
control lever.
Attach the throttle cable to the engine using the
Attach the throttle cable to the engine using the
14.
double wire clamp removed previously.
Test throttle control by pulling back throttle handle
15.
on console. Throttle arm on engine should be
pushed completely forward. Cable should not slip
in clamp when doing this test.
Test proper wire length by pulling on the handle
Test proper wire length by pulling on the handle
16.
adjustment lever and raising and lowering the
handle to maximum position without any pull on
harness.
Reattach air cleaner to engine.
Reattach air cleaner to engine.
17.
Remove unit from pallet.
18.