Gerber Tools Saw 600 用户手册

4 – 5

When the AUTO PRE-FEED function is set to “ON,” the medium is automatically fed forward and back-

ward by the preset length when data is received. This operation leaves traces of the grit rollers on the

media and prevents it from slipping during a cutting or plotting operation. Similarly, if roll media is used, the

medium is automatically pulled out by the cutting plotter.

Press the 

 (PAUSE) key to switch to PAUSE mode.

Press the 

 (NEXT) or 

 (PREV.) key until the following menu is displayed.

Press the 

 (ENTER) key to display the AUTO PRE-FEED setting.

Press the 

 or  

key to select “ON” or “OFF,” and then press the 

 (ENTER)

key to confirm.

If “ON” is selected and the 

 (ENTER) key pressed, the feed-length setting is

displayed.

Use the 

 or 

 key to set a value within the range of 1 m to 50 m, and then

press the 

 (ENTER) key to confirm. To cancel the selection, press the 

(NEXT) or 

 (PREV.) key.

Press the 

 (PAUSE) key to cancel PAUSE mode.

When using roll media, either extend and load the length to be
used beforehand or use the media feed procedure (“4.3 Setting
the FEED function”, “4.4 Setting AUTO PRE-FEED”).
Beginning cutting or plotting without feeding the media first may
generate a position error or may cause the roll media to fall off
the stock shaft.