Gerber Tools Saw 600 用户手册

4 – 6

This function should be used for the cutting of thick media (more than 0.3 mm in thickness) and when the

cutter blade is not able to turn properly due to the cutting depth, resulting in discrepancies between the

start and finish point and the inability to cut sharp corners. This function can be set on or off individually for

each of the eight cutter-pen setting areas, and it should be set to suit the media used. The overcut-amount

setting screen is displayed for cutter-pen setting areas for which the TANGENTIAL mode is “ON.”

This setting has two modes: Mode 1 and Mode 2.

Mode 1: Overcuts the start and finish cutting positions and acute-angle corner sections to avoid leaving

uncut sections. In addition, the cutter blade is moved on the surface of the medium during cutting

when it is rotated significantly, ensuring sharp cutting unaffected by the medium toughness or

thickness.

Mode 2: Overcuts the start and finish cutting positions only. In addition, the cutter is rotated on the medium

surface for the start cutting position only. This uses simpler cutter control than Mode 1, and pro-

vides a shorter cutting time.

Press the 

 (PAUSE) key to switch to PAUSE mode.

Press the 

 (NEXT) or 

 (PREV.) key until the following menu is displayed.

Press the 

 (ENTER) key to display the TANGENTIAL setting. The numbers “1”

to “8” indicate the cutter setting areas, and those marked with a   symbol have

the TANGENTIAL mode set to “ON.”

Use the 

 and  

keys to move the cursor and select a setting area. Use the 

and  

keys to display/not display the   symbol, and then press the 

 (ENTER)

key to confirm. To cancel the selection, press the 

 (NEXT) or 

 (PREV.) key

Press the 

 (PAUSE) key to cancel PAUSE mode.

Select the condition-setting area to be set to “ON” (refer to “Selecting Cutter-Pen-