Avaya Media Gateway G700 用户手册

Note:

Avaya P330 Stack Processors now support a "Faststart" or "Portfast" function, 
because the 802.1w standard defined it. An edge port is a port that goes to a 
device that cannot form a network loop. 
To set an edge-port, type set port edge admin state module/port 
edgeport

.

For more information on the Spanning Tree CLI commands, see the Avaya P330T User’s Guide 
(available at 

!

Important:

The administration procedures in this section are done on the media server that 
is the primary controller for the new G700 you previously installed. This primary 
controller may or may not be the S8300 you installed in the G700.

The primary controller for the G700 you are installing must be administered to enable 
communication between the primary controller and the G700. The administration differs 
somewhat depending on whether the primary controller is an S8300 or the primary controller is 
an S8400, S8500, or S8700-series Media Server. 

Perform one of the following two administration procedures in this section:

●

●

This document covers only the administration of Communication Manager required for the 
G700 media gateway to communicate with the primary controller over a customer’s network. 
For the majority of administration required, see Administrator Guide to Avaya Communication 
Manager, 03-300509, or Administration for Network Connectivity for Avaya Communication 
Manager, 555-233-504.

In this section, you will use the SAT interface to:

●

●

●

●

●