BMW 2008 M3 Sedan 业主指南
123
3 Connector and cable for the cigarette
lighter socket
4 Holder for the sealant bottle
5 Compressor
6 On/off switch
7 Pressure gauge for displaying the tire infla-
5 Compressor
6 On/off switch
7 Pressure gauge for displaying the tire infla-
tion pressure
8 Screw on pressure gauge to reduce tire
inflation pressure
9 Hose to connect compressor and sealant
bottle or compressor and wheel
The connector, cable and connection hose are
stored in the compressor housing.
stored in the compressor housing.
Using the M Mobility System
To repair a flat tire with the M Mobility System,
proceed as follows:
proceed as follows:
>
Fill the sealant, refer to page
.
>
Distribute the sealant, refer to page
>
Produce the tire inflation pressure, refer to
page
page
123
.
Filling the sealant
Strictly follow the specified sequence,
otherwise the sealant may escape under
otherwise the sealant may escape under
high pressure.
<
1.
Shake the sealant bottle.
2.
Screw connection hose
9 onto the connec-
tor of the sealant bottle.
3.
Ensure that screw
8 on the pressure gauge
is closed.
4.
Unscrew the dust cap from the valve of the
defective wheel and screw filling hose
defective wheel and screw filling hose
2 of
the sealant bottle onto the valve.
5.
Insert the sealant bottle into the housing of
the compressor so that the bottle is upright.
the compressor so that the bottle is upright.
6.
Ensure that the compressor is switched off,
position 0.
position 0.
7.
Insert connector
3 into the cigarette lighter
socket in the interior of the vehicle, refer to
page
page
.
8.
With the ignition switched on:
Switch on the compressor and let it run for
approx. 3 minutes to fill the sealant. The
inflation pressure of the tire after filling is
unimportant.
Switch on the compressor and let it run for
approx. 3 minutes to fill the sealant. The
inflation pressure of the tire after filling is
unimportant.
9.
Switch off the compressor.
10.
Detach the hoses from the sealant bottle
connector and from the tire valve.
Return the M Mobility System to its storage
location in the vehicle.
connector and from the tire valve.
Return the M Mobility System to its storage
location in the vehicle.
Distributing the sealant
Immediately drive approx. 2 miles/3 km to
evenly distribute the sealant in the tire.
evenly distribute the sealant in the tire.
Do not exceed a speed of 35 mph/
60 km/h. If possible, do not fall below a
60 km/h. If possible, do not fall below a
speed of 12 mph/20 km/h.
<
Producing the tire inflation pressure
1.
After driving approx. 2 miles/3 km, stop at a
suitable location.
suitable location.
2.
Connect connection hose
9 of the com-
pressor directly to the tire valve.
3.
Insert connector
3 into the cigarette lighter
socket in the interior of the vehicle.
Online Edition for Part no. 01 41 0 014 956 - © 02/08 BMW AG