Broil-Mate 115997 NG 用户手册

TROUBLE SHOOTING

PROBLEM

POSSIBLE CAUSE

CORRECTIVE ACTION

SMELL OF GAS

SHUT OFF GAS SUPPLY VALVE AT ONCE.
DO NOT USE THE APPLIANCE UNTIL LEAK IS SEALED.

Leak detected at any connection.

1. Quick disconnect coupling not

seated fully.

1. Remove and reconnect coupling.

2. Gas leak in connection.

2. Tighten connection and "Leak Test".

3. Gas leak in hose or control

valves.

3. See authorized service centre.

Flame flashback beneath control panel. 1. Venturi blocked.

1. Remove burner, clean venturi. See

"Venturi Tubes".

Burner will not light.

1. Gas shut off valve closed.

1. Open gas shut off valve.

2. Ignitor wire(s) not connected.

2. Connect both main burner and side

burner electrode wires.

3. Ignitor electrode misaligned on

burner.

3. Realign

electrode.

4. Ignitor

malfunction.

4. Use "Manual Lighting" Procedure.

5. Venturi

blocked.

5. Remove burner, clean venturi. See

"Venturi Tubes".

6. Venturi not aligned with valve

orifice.

6. Realign venturi to orifice. See

"Venturi Tubes".

7. Orifice blocked.

7. Remove burner, clean orifice with a

pin or fine wire. Do not attempt to
drill orifice.

Hot spots on cooking surface.

1. Briquets not evenly distributed.

1. Spread briquets evenly on briquet

grate - one layer only.

2. Venturi

blocked.

2. Remove burner, clean venturi. See

"Venturi Tubes".

"Flare-ups" or grease fires.

1. Excessive grease buildup on

briquets.

1. Clean briquets. See "Maintenance".

2. Excessive heat.

2. Turn burner controls to a lower

setting or raise cooking grid to
upper position (2-position grids
only).

Yellow Flame.

1. Some yellow flame is normal. If it

becomes excessive the venturi
may be blocked.

1. Remove burner, clean venturi. See

"Venturi Tubes".

2. Burner ports blocked.

2. Remove burner and clean with soft

bristle brush or scraper.

Inside of lid appears to be peeling.

1. This is a build up of grease not

faulty paint.

1. Clean with stiff bristle brush or

scraper.