Whirlpool GX900QPPB 业主指南

4. Wash the interior of the drawer with a clean sponge or soft 

cloth and a mild detergent in warm water. Rinse and dry 
thoroughly with a soft cloth. 

5. If the drawer side was removed, slide it back into the tilted 

position.

6. Press the lever-action lock (or Side-Lock Latch) down while 

pushing the drawer side to the upright position. 

7. Latch the drawer side by pushing up the lever-action lock (or 

Side-Lock Latch).

NOTE: You may want to wear gloves since there may be bits of 
glass in the cabinet.

1. Pull the drawer out until it stops.

NOTE: Look to see how the drawer rollers move in the tracks. 
It will be easier to replace the drawer after you have finished 
cleaning. 

2. Lift the front of the drawer to clear the stops.

3. Grasp the drawer on the sides and pull it out the rest of the 

way. Set the drawer down gently.

4. Vacuum the inside of the cabinet. Liquid spills or wet trash 

should be cleaned up by hand, or by using a vacuum 
designed to pick up liquids.

5. Wash the inside of the cabinet with a clean sponge or soft 

cloth and a mild detergent in warm water. Rinse and dry 
thoroughly with a soft cloth.

6. To replace the drawer, grasp it by the sides and insert the 

rollers onto the tracks.

7. Lift the front of the drawer and push it in fully past the stops.

NOTE: You may want to wear gloves since there may be bits of 
glass on the ram cover.

1. Wipe glass particles off of the ram cover with a cloth or paper 

towels. 

2. Remove foods with a clean sponge or soft cloth and a mild 

detergent in warm water. Rinse and dry thoroughly with a soft 
cloth.

If you will be away for more than a couple of days, remove the 
compactor bag. Remove the Key-Knob (or Key-Switch) and store 
it out of children’s reach. 

■

Is the drawer less than half-full? Drawer must be more than 
half full before trash is compacted.

■

Is the power supply cord unplugged? Plug into a grounded 
3 prong outlet.

■

Has a household fuse blown, or has a circuit breaker 
tripped? Replace the fuse or reset the circuit breaker. If the 
problem continues, call an electrician.

■

Is the drawer completely closed? Close the drawer firmly 
and start the compactor again.

■

Is the Key-Knob turned all the way to START? Turn the 
Key-Knob (Key-Switch) fully to START and release (on some 
models). See “Starting the Compactor.”

■

Did you press ON before pressing START? Press ON 
before pressing START (on some models). See “Starting the 
Compactor.”