Whirlpool GX900QPPB 业主指南

3. Push Side-Lock Latch down and tilt drawer side open.

4. Lift out bag. 

Do not use any kind of bag other than those designed especially 
for use in your compactor. Order replacement compactor bags 
through your local dealer or by calling the toll-free number on the 
cover or in the “Assistance or Service” section.

Before installing a new bag, be sure:

■

The drawer side is securely locked.

■

The container is clean and free of debris.

1. Place folded bag into the drawer. Open bag and pull top 

edges over the drawer top. 

2. Lock bag in place by pulling the four prepunched holes over 

the bag retainer buttons. Holes will expand over the buttons 
without damaging the bag.

3. Press inside of bag against the drawer bottom, sides and 

corners for a smooth fit. 

Your new compactor is designed to give you many years of dependable service. However, there are a few things you are expected to do 
in order to properly maintain your compactor. This section will tell you how to clean and care for your compactor.

Before cleaning the compactor, turn the Key-Knob (or Key-
Switch) to the OFF & LOCK position and remove it.

NOTE: Any services other than those outlined in this section 
should be performed by a designated service representative.

1. Wash exterior surfaces (including stainless steel) with a clean 

sponge or soft cloth and a mild detergent in warm water. Do 
not use abrasive or harsh cleaners. Rinse and dry thoroughly 
with a soft cloth. 

2. Wipe up spills right away. Some foods can damage the finish 

if left on the compactor surface.

NOTE: You may want to wear gloves since there may be bits of 
glass in the drawer. 

1. Remove the bag. See the “Removing a Filled Bag.”

2. Press down on the lever-action lock (or Side-Lock latch).

3. Hold the lever-action lock down and tilt the side of the drawer 

out until the lock clears the drawer front.

NOTE: If desired, the drawer side can be removed by tilting it 
up, then lifting it out.