Wasp Bar Code WPS100 用户手册
2-8
Wasp WPS100 Product Reference Guide
Selecting Beeper Volume using Trigger
The scanner emits a short beep when it successfully reads a bar code. The volume of the
beep can be changed either by scanning the appropriate bar code in
beep can be changed either by scanning the appropriate bar code in
page 4-7, or by utilizing the trigger as follows:
1. Press and hold the trigger for an extended period of time (approximately 5
seconds). The scanner cycles through three settings (Low, Medium, High) emitting
a 2-beep tone at each setting.
a 2-beep tone at each setting.
2. To select a particular setting, release the trigger after the desired 2-beep tone is
heard.
Lo/hi/lo beep
The Code 39 buffer was erased or there was an
attempt to clear or transmit an empty buffer.
attempt to clear or transmit an empty buffer.
Lo/hi beep
A successful transmission of buffered data.
Host Specific
USB only
4 short high beeps
Scanner has not completed initialization. Wait
several seconds and scan again.
several seconds and scan again.
Scanner gives a power-up
beep after scanning a USB
Device Type.
beep after scanning a USB
Device Type.
Communication with the bus must be established
before the scanner can operate at the highest
power level.
before the scanner can operate at the highest
power level.
This power-up beep occurs
more than once.
The USB bus may put the scanner in a state where
power to the scanner is cycled on and off more than
once. This is normal and usually happens when the
PC cold boots.
power to the scanner is cycled on and off more than
once. This is normal and usually happens when the
PC cold boots.
Table 2-1. Standard Beeper Definitions
Beeper Sequence
Indication