Whirlpool UXL5430BSS 使用和维护

■

It is recommended that the vent system be installed before 
the range hood is installed.

■

Before making cutouts, make sure there is proper clearance 
within the ceiling or wall for vent fittings.

■

Making the cutout to the bottom of the cabinet may be easier 
to do prior to mounting the cabinet to the wall.

1. Disconnect power.

2. Determine which venting method to use: roof, wall, or non-

vented.

3. Select a flat surface for assembling the range hood. Place 

covering over that surface.

4. Using 2 or more people, lift range hood onto covered surface.

1. Use a saber saw or keyhole saw to cut out the cabinet 

bottom inside the cabinet frame.

NOTE: Frameless type cabinets require ¾" (1.9 cm) front lip 
in the cabinet bottom. A ¾" (1.9 cm) thick filler strip (not 
supplied) may be required for some types of cabinets. (See 
Step 3 in the “Install Range Hood” section.)

2. Complete cabinet preparation following the instructions for 

your type of venting. Determine venting cutout locations and 
cut out vent openings in the cabinets, walls and/or soffit.

Measure and mark the lines as shown. Use a saber saw or 
keyhole saw to cut an opening through the top of the cabinet 
and the roof for the vent.

Go to Step 3.

*NOTE: For 12" (30.5 cm) high cabinets, a 6¼" deep x 8" wide 

(14.6 cm x 20.3 cm) rectangular opening in the cabinet top is 
required for damper transition clearance.

Install the 6" (15.2 cm) vent transition to the top of the range 
hood liner using two 3.5 x 9.5 mm screws. Assemble the vent 
duct that you will use over the 6" (15.2 cm) vent transition. 
Measure from the bottom of the range hood liner to the 
horizontal centerline of the vent opening (A).

Remove the vent duct from the range hood liner.

⁷⁄₈

³⁄₄

A

B

C

D

E

³⁄₄

D

A

B*

C

A

B

C