Whirlpool UXL5430BSS 使用和维护

Transfer measurement A to the cabinet back wall. Measure 
from the underside of the cabinet. Mark the cutout as shown. 
Use a saber saw or keyhole saw to cut a round opening 
through the back of the cabinet and the exterior wall for the 
vent.

Go to Step 3.

Measure and mark the centerline of the cabinet to the soffit 
above.

Measure from the bottom of the cabinet to the centerline of 
the where the vent will come through the soffit. Mark the 
location and use a saber saw or keyhole saw to cut a 5¾" 
(14.6 cm) hole for the vent cover.

Measure and mark the centerline location for the cutout in the 
cabinet top. Use a saber saw or keyhole saw to cut an 
opening for the vent.

For non-vented (recirculating) installations only, the range 
hood can be vented indoors through the top of the cabinet.

For non-vented (recirculating) installations, charcoal filters are 
necessary. See the “Range Hood Care” section for 
instructions on installing charcoal filters.

The Recirculation Kit Part Number W10490330 must be used.

B

A

C

A

B

³⁄₄

12" (30.5 cm)

A 6¼" deep x 8" wide (15.9 cm x 20.3 cm) 
rectangular opening in the cabinet top is 
required for damper transition clearance.

15" (38.1 cm) 
cabinet or soffit 
installation

A 6¼" (15.9 cm) diameter round opening is 
required.

18" (45.7 cm) or 
24" (61.0 cm)

A 5¾" (14.6 cm) diameter round opening is 
required.

D

A

B*

C