GE Mark Controls Upgrades 数据表
Mark VI Training Simulator
Introduction
Improve the effectiveness of your operations and maintenance
with GE Energy’s Mark VI Training Simulator. The training
simulator uses your actual site-specific application software
and operator screens to drive the turbine simulation.
Operators can refresh their knowledge of commands and
system responses on a replica of the actual turbine control –
with no risk to the turbine. Training can occur on site, for any
shift, at your convenience and be repeated days, weeks, or
years later for new personnel.
Maintenance personnel can also train on editing and
downloading real turbine software, trend parameters as they
actually respond on the unit, and exercise the wide range of
advanced analysis tools that are available to maintain the
turbine. The training software can even be updated to reflect
changes made on the real unit and be compared with the
original code – it’s the real deal!
Availability
The Training Simulator is available for all Mark VI control
systems applied to any gas or steam turbine with a generator
or mechanical load. It is also available for power island
applications, such as Heat Recovery Steam Generator (HRSG),
and balance of plant applications, such as combined cycle
plants. GE Energy can also provide an experienced instructor
to teach a regular training course or a customized program at
your site.
Benefits
• Operators – Improved effectiveness in using screens, alarm
management, and trending
• Maintenance – Decreased time required to troubleshoot
problems and maintain unit availability
• Refresh Skills – Revisit basic tasks that are infrequently
needed, but still important in the modern age of
automated controls
• Life Cycle Cost – A permanent, onsite, simulator to provide
effective, ongoing training for the life of the control system
GE Energy
Energy Learning Center
fact sheet