National Instruments NI Vision NI 17xx 用户手册

Use the NI Smart Camera only with a 24 VDC, UL listed, limited power source 

(LPS) supply. The power supply should bear the UL listed mark, LPS. The power supply 
must meet any safety and compliance requirements for the country of use.

The smart camera uses a nominal 24 VDC power source. The smart camera 
accepts power within the range of the industry standard IEC 1311 input 
power specification (24 V +20%/–15% with an additional allowance for an 
AC peak of +5%). Refer to Appendix A, 

, for complete 

power requirement specifications.

The 24 V external lighting strobe is an unregulated output dependent on the range 

of the power supply provided to the smart camera. If the power provided to the smart 
camera is +20%/–15% with +5% AC ripple, the external lighting strobe output could be 
as high as 30 V. If the provided power exceeds the input voltage specifications of the 
third-party lighting controller, do not connect the 24 V lighting strobe output to the 
controller to prevent damage to the controller. Use a power supply with tolerances that 
meet the requirements of the controller, or use the 5 V external lighting strobe.

TrigIn–

IsoIn(0)–
IsoIn(1)–

12

Light Green

IsoOut(0)+

6

Yellow

IsoOut(0)–

1

Green

IsoOut(1)+

11

Light Blue

IsoOut(1)–

7

Gray

PhaseA+

3

Blue

PhaseA–

13

Brown/White

PhaseB+

9

Purple

PhaseB–

4

White

Table 2-1.  POWER-I/O Connector Signal Descriptions (Continued)

5 (+24 V)

15 (COM)

11

6

1

10