National Instruments NI Vision NI 17xx 用户手册
Chapter 6
LEDs and DIP Switches
6-6
ni.com
NO APP Switch
Move the NO APP switch to the ON position to prevent a startup
application from running when the NI Smart Camera powers on. If you
want to permanently disable the application from running when the smart
camera powers on, you can disable the startup application in software.
application from running when the NI Smart Camera powers on. If you
want to permanently disable the application from running when the smart
camera powers on, you can disable the startup application in software.
To automatically run an application when the smart camera powers on,
keep the NO APP switch in the OFF position. You must configure the
application in software to automatically run when the smart camera powers
on. Refer to the LabVIEW Real-Time Module Help for more information
about automatically launching VIs when the smart camera powers on.
Refer to the NI Vision Builder for Automated Inspection: Configuration
Help for more information about configuring remote target options.
keep the NO APP switch in the OFF position. You must configure the
application in software to automatically run when the smart camera powers
on. Refer to the LabVIEW Real-Time Module Help for more information
about automatically launching VIs when the smart camera powers on.
Refer to the NI Vision Builder for Automated Inspection: Configuration
Help for more information about configuring remote target options.
Keep the NO APP switch in the OFF position during normal operation.
CONSOLE Switch
With a serial port terminal program, you can use the CONSOLE switch to
read device information from the NI Smart Camera during startup, such as
the IP address and firmware version. When the CONSOLE switch is in the
ON position, the serial port outputs device information and is not available
for applications. The smart camera reads this switch only when powering
up or restarting and will only display device information during startup.
read device information from the NI Smart Camera during startup, such as
the IP address and firmware version. When the CONSOLE switch is in the
ON position, the serial port outputs device information and is not available
for applications. The smart camera reads this switch only when powering
up or restarting and will only display device information during startup.
When the CONSOLE switch is in the OFF position, you can use the smart
camera serial port and NI-Serial driver software to send and receive serial
data. The NI-Serial software is installed when you install NI-IMAQ. When
using the NI-Serial driver, keep the CONSOLE switch in the OFF position
during normal operation.
camera serial port and NI-Serial driver software to send and receive serial
data. The NI-Serial software is installed when you install NI-IMAQ. When
using the NI-Serial driver, keep the CONSOLE switch in the OFF position
during normal operation.
Refer to the
section of Chapter 2,
, for more information about using serial communication with the smart
camera.
S
AFE MODE
IP RE
S
ET
NO APP
CON
S
OLE
ON
S
AFE MODE
IP RE
S
ET
NO APP
CON
S
OLE
ON