RTI ID900 用户手册

c)  When the hose is completely dry inspect the hose for signs of wear as described above. 

 

Inspection Frequency: The instrument will inform the user of possible air detection replacement requirements with the 
error code Replace Air Sensor. 

Air Detection Sensor Replacement Procedure: 

a)  Refer to the error code corrective actions and try each suggested action. If the instrument still indicates the error 

code then the air detection sensor will require replacement. 

b)  Power down the instrument and remove the sample hose from the instrument sample inlet port. 

c)  Turn the instrument onto its face and remove the eight phillips head screws from the rear countersunk holes. 

d)  Carefully remove the instrument case front to expose the internal components. 

e)  Carefully lift the control circuit board and disconnect the air detection sensor harness from the circuit by pulling 

straight out of the circuit board connector. 

f)  Lift the air detection sensor housing straight up from the instrument off of the support pins and remove the 

sensor by unthreading. Discard the spent sensor. 

g)  Obtain a replacement air detection sensor, part number 1-16-1013-00-0, and install it into the housing by 

threading to hand-tight. 

h)  Replace the housing into the instrument by seating the housing through holes over the two case pins. 

i) 

Route the sensor harness to the circuit board and plug it into the sensor harness header of the circuit by pressing 
straight in. The harness is keyed and will only fit securely in one direction. 

j) 

Verify that the circuit board is properly positioned onto the mounting studs of the instrument case. 

k)  Secure the housing halves together using the eight phillips head screws. 

 

 

Spare parts are available directly from the Neutronics Incorporated Sales or Service Department. To order spare parts 
contact Neutronics Incorporated by phone at (610) 524-8800 or by fax at (610) 524-8807. Have a shipping name, address 
and purchase order number ready as well as the model and serial number of the instrument and the part number of the spare 
part. 

 

User 

Instruction 

Manual 

    035-80979-00 

Sample 

Filter 

     026-80128-00