ONKYO A-9377 用户手册
14
Connecting
Components
Connecting the A-9377 to your other Onkyo
-capa-
ble components with
cables allows you to control
them all with the A-9377’s remote controller, like an
integrated system, with the following functionality.
integrated system, with the following functionality.
Direct Change
When playback is started on a component connected
with
When playback is started on a component connected
with
, the A-9377 will automatically select that
component as the input source.
Remote Control
You can control components connected with
You can control components connected with
from
the A-9377’s remote controller. See page 9 for details.
To use all
functionality, in addition to an
con-
nection, each component must be connected to an
analog audio input on the A-9377.
analog audio input on the A-9377.
Notes:
• Push plugs in all the way to make good connections.
•
• Push plugs in all the way to make good connections.
•
cables are special cables solely for use with
Onkyo products (no
cables are supplied with the
A-9377). Use only
cables for
connections.
• Connect
jacks to only
-capable Onkyo compo-
nents. Connecting them to other manufacturers’ com-
ponent may cause a malfunction.
ponent may cause a malfunction.
• Some
-capable Onkyo components may not sup-
port all
functionality. Refer to each component’s
instruction manual for full details.
Connecting the Power Cords of Other
Components
Components
The A-9377 has switched AC outlets on its rear panel
that can be used to connect the power cords of other
components that you intend to use with the A-9377.
These components can then be left turned on so that
they turn on and off as and when the A-9377 is turned
on and off.
Use the AC outlets for components that have no Standby
function, such as the Onkyo CD Player.
that can be used to connect the power cords of other
components that you intend to use with the A-9377.
These components can then be left turned on so that
they turn on and off as and when the A-9377 is turned
on and off.
Use the AC outlets for components that have no Standby
function, such as the Onkyo CD Player.
-capable
Onkyo components with a Standby function must be
connected directly to a wall outlet.
connected directly to a wall outlet.
Cautions:
• Connect only audio components to the AC OUT-
• Connect only audio components to the AC OUT-
LETS.
• Make sure the total capacity of the components you
connect to the AC OUTLETS does not exceed the
maximum capacity stated on the A-9377’s rear panel
(TOTAL 100 W).
maximum capacity stated on the A-9377’s rear panel
(TOTAL 100 W).
Connecting the A-9377’s Power Cord
• Before connecting the power cord, connect all of your
speakers and audio components.
• Turning on the A-9377 may cause a momentary power
surge, which might interfere with other electrical
equipment on the same circuit. If this is an issue, plug
the A-9377 into a different branch circuit.
equipment on the same circuit. If this is an issue, plug
the A-9377 into a different branch circuit.
For optimum performance, plug the A-9377 into its own
wall outlet. Do not connect it to a wall outlet that’s also
used by a high-power appliance, such as a heater.
wall outlet. Do not connect it to a wall outlet that’s also
used by a high-power appliance, such as a heater.
Onkyo CD player,
Onkyo cassete deck,
Onkyo tuner, etc.
Onkyo cassete deck,
Onkyo tuner, etc.
A-9377
jacks
cables
jacks
Onkyo RI Dock
Power Connections
To wall outlet