National Instruments Power Supply shuttle NI PXIe-1062Q 用户手册

© National Instruments Corporation

The power supply shuttle is designed with a three-position NEMA 5-15 

(IEC 60320) jack that connects the ground line to the chassis ground. To minimize 
shock hazard, make sure the electrical power outlet you use to power the chassis has 
an appropriate earth safety ground.

If your power outlet does not have an appropriate ground connection, you 
must connect the premise safety ground to the chassis grounding screw. 
Refer to Figure 1 to locate the chassis grounding screw. To connect the 
safety ground, complete the following steps:

1.

Connect a 16 AWG (1.3 mm) wire to the chassis grounding screw 
using a grounding lug. The wire must have green insulation with a 
yellow stripe or must be noninsulated (bare).

2.

Attach the opposite end of the wire to permanent earth ground using 
toothed washers or a toothed lug.

Input voltage range................................. 100 to 240 VAC

Operating voltage range

1

........................ 90 to 264 VAC

Input frequency ...................................... 50/60 Hz

Operating frequency range

1

................... 47 to 63 Hz

Input current rating................................. 8 A

Over-current protection.......................... 10 A circuit breaker

Line regulation

3.3 V................................................ <±0.2%

5 V................................................... <±0.1%

±12 V .............................................. <±0.1%

1   

The operating range is guaranteed by design.