Whirlpool UXT5536AAS 手册

■

Remove screws and rear support.

■

Remove the blower mounting screws. Push up on the 
blower to detach the blower from the mounting plate. 

■

Remove the vent knockout from the front mounting plate.

■

Rotate the blower and attach to front mounting plate. 
Install the blower mounting screws.

■

Install charcoal filters. See the “Range Hood Care” 
section.

8. Using 2 people, lift range hood into final position, feeding 

electrical wire through wiring opening. Position the range 
hood so that the large end of the keyhole slots are over the 
screws. Then push the hood toward the wall so that the 
screws are in the neck of the slots. Tighten mounting screws 
to cabinet, making sure mounting screws are in narrow neck 
of slots. 

9. Check that damper, if used, rotates up and down freely.

10. Reinstall the rear support.

11. Replace the 2 lateral supports.

12. Replace filters. See the “Range Hood Care” section.

13. Plug 3-prong power cord into a grounded 3-prong outlet 

located inside the cabinet above the range hood.

Connect ventwork to hood. Seal joints with clamps to make 
secure and airtight.

1. Replace grease filters. See the “Range Hood Care” section.

2. Check the operation of the range hood fan and light. See 

“Range Hood Use” section.

If range hood does not operate, check to see whether a 
circuit breaker has tripped or a household fuse has blown. 
Disconnect power and check wiring connections. 

NOTE: To get the most efficient use from your new range hood, 
read the “Range Hood Use” section.

The range hood is designed to remove smoke, cooking vapors 
and odors from the cooktop area. For best results, start the hood 
before cooking and allow it to operate several minutes after the 
cooking is complete to clear all smoke and odors from the 
kitchen.

The hood controls are located on the center of the range hood.

A

A

B

C

A

B

A

B

C

D