Maytag UXT3030AD 安装指导

8. Prepare Range Hood Vents and 

Mounting Tabs

■

Install a UL Listed/CSA Approved 

¹⁄₂" (13 mm) strain relief (A).

■

Start a #8-18 x 

⁵⁄₈" (4.2 x 16 mm) truss-head screw into the 

mounting tab (D) on each side of the range hood as shown in 
the inset. Insert the screws approximately 2 turns into the 
mounting tab holes.

■

For top vent installations, remove the top, rectangular vent 
knockout (C).

For wall vent installations, remove the rear rectangular vent 
knockout (B).

9. Attach Vent Damper or Transition 

Using (2) short Phillips head screws, install the 3

¹⁄₄" x 10" (8.3 x 

25.4 cm) rectangular damper over the top or rear vent knockout 
removed in Step 8.

NOTE: If the wall cap used has a damper and it interferes with 
the rectangular damper, remove the rectangular damper flap.

10. Mount Range Hood 

■

Lift the range hood into place, positioning the rear slots over 
the mounting brackets.

■

Using a Phillips screwdriver, push on the screws that are 
started into the top mounting tabs and bend the tabs against 
the cabinet side walls. Attach the screws to the cabinet side 
walls. 

IMPORTANT: Do not overtighten the screws.

■

For direct wire installations, run the home power supply cable 
according to the National Electric Code or CSA standards 
and local codes and ordinances. There must be enough 
wiring from the fused disconnect (or circuit breaker) box to 
make the connection in the range hood electrical terminal 
box. 

■

Tighten the strain relief screws.

NOTE: Do not reconnect power until the installation is 
complete.

OPTIONAL: If you prefer, bend the rear tabs against the rear 
of the range hood and attach to the wall using #8-18 x 

⁵⁄₈" 

(4.2 x 16 mm) truss-head screws.

11. Connect Vent System

■

Connect the ventwork to the range hood. 

■

Seal joints with duct tape to make secure and airtight.

■

Check that the back draft dampers work properly.

A

B

C

D