Viking RVCH330X 安装指导
11
10
CAUTION: If not using a duct cover, using
screws provided make sure top mounting screws are
secured into soffit or cabinet frame. Use additional
mounting screws, if necessary.
Connect black to black, white to white, and the
green/bare wire under the green screw.
NOTE:
Housing wiring must be properly installed for
wiring to be correct when wiring unit.
wiring to be correct when wiring unit.
5/16”
nut driver
BLACK
BLACK
WHITE
WHITE
GREEN
BARE OR GREEN
7
Replace electrical box cover. Make connection to
breaker box.
1
2
3
9
1
1
2
8
Slide spacer front over front lip. Push spacer rear up,
then slide back over rear lip.
Slide filter front over front lip. Push filter rear up,
then slide back over rear lip.
2
1
3
10
3
4
2
Place duct cover top inside duct cover base and lower until
desired height is found. Mark height. Use the retaining nuts and
bolts to fasten in place from the inside and remove tape.
Slide duct cover in place and fasten from inside
canopy using the sheet metal screws provided.
1
2
Measure distance from ceiling to canopy.
Tape to avoid scratching.
Duct Cover
(RVCH Classic Chimney Wall Hoods w/Standard Ventilator)
CAUTION: Secure vent hood to wall using screws
provided. Use additional mounting screws and
wall anchors, if necessary.
6
5/16”
nut driver
2
1
3
11
Slide filter front over front lip. Push filter rear up,
then slide back over rear lip.