White Westinghouse WWFH20F2RC 业主指南

4



It is VERY IMPORTANT for your appliance  

to be level in order to function properly. If the 

unit is not leveled during installation, the door/

lid may be misaligned and not close or seal 

properly, causing cooling, frost or moisture 

problems.



The exterior walls of the unit may become 

quite warm as the compressor works to 

transfer heat from the inside. Temperatures 

as much as 30° F warmer than room 

temperature can be expected. For this reason 

it is particularly important in hotter climates 

to allow enough space for air circulation 

around your appliance.

The appliance must have all bottom corners 

resting firmly on a solid floor. The floor must be 

strong enough to support a fully loaded unit.  

This Use & Care Guide provides general operating 

instructions for your model. Use the unit only 

as instructed in this Use & Care Guide. Before 

Choose a place that is near a grounded  

electrical outlet. 
For the most efficient operation, the appliance 

should be located where surrounding 

temperatures will not exceed 110°F (43°C). 

Temperatures of 32°F (0°C) and below will 

NOT affect operation. Additional compressor 

heaters are not recommended.
Allow space around the unit for good air 

circulation. Leave a 3 inch (75 mm) space on 

all sides of the unit for adequate circulation.

To allow door to close and seal properly, DO 

NOT let food packages extend past the front  

of shelves.

3” (75 mm)

3” (75 mm)

3” (75 mm) Air Space

3” (75 mm)

To level Upright Units:
After discarding crating screws, use a 

carpenter’s level to level the appliance from 

front to back. Adjust the plastic leveling feet in 

front, ½ bubble higher, so that the door closes 

easily when left halfway open.

1.  To remove the support-hanging basket, 

press upward on underside of front of 

support to release from shelf rod.

2.  Rotate front under the shelf, and then 

slide support-hanging basket forward to 

remove from back shelf rod.

3.  To remove shelf grommet, slide away 

from wall, then pull from rod.

4.  Repeat steps 1-3 for other side.
5.  With the shelf installed, press the 2 shelf 

grommets down onto the rod that is 

3" (75 mm)

3" (75 mm)

3"
(75 mm)

To level Chest Units:
If needed, add metal or wood shims between 

feet pads and floor.