White Westinghouse WWFH20F2RC 业主指南

6



Your freezer may have some, or all of the 

features listed below. Become familiar with 

these features, and their use and care.

•  For safe food storage, allow 4 hours for 

the appliance to cool down completely. 

The unit will run continuously for the first 

several hours. Foods that are already 

frozen may be placed in the unit after the 

first few hours of operation. Unfrozen foods 

should NOT be loaded into freezer until 

freezer has operated for 4 hours.

•  When loading freezer, freeze only 3 pounds 

of fresh food per cubic foot of freezer 

space at one time. Distribute packages to 

be frozen evenly throughout the freezer. It 

is not necessary to turn control knob to a 

colder setting while freezing food.

The temperature control is located inside the 

freezer on upright models, and on the left 

exterior wall on chest models. The temperature 

is factory preset to provide satisfactory 

food storage temperatures. However, the 

temperature control is adjustable to provide 

a range of temperatures for your personal 

satisfaction. If a colder temperature is 

desired, turn the temperature control knob 

toward COLDEST and allow several hours for 

temperatures to stabalize between adjustments.

(some upright frost-free models)
The electronic temperature control is located 

outside the freezer on upright models. The 

temperature is factory preset to provide 

satisfactory food storage temperatures. To 

adjust the temperature setting, press the + 

button for a warmer temperature and the - 

button for a colder temperature on the control 

panel. Allow several hours for the temperature 

to stabilize between adjustments.

1.  Gently lay the unit on its back, on a rug  

or blanket.

2.  Remove 2 base screws and base panel. 
3.  Unplug connector, if required, by holding 

the cabinet connector in place, and 

pulling door connector out. If equipped, 

pull Harness Retainer from Cabinet.

4.  Remove 4 bottom hinge screws.
5.  Remove plastic top hinge cover.
6.  Remove 2 screws from top hinge.
7.  Remove top hinge from cabinet.
8.  Remove door and bottom hinge  

from cabinet.

9.  To replace door, reverse the above 

order and securely tighten all screws to 

prevent hinge slippage. Ensure the door 

harness is routed as shown and that the 

restraint clip is snapped into the cabinet.

Base Screw

Hinge

Screws

Wire

Door 

Connector

Cabinet

Connector

Harness

Restraint

See Instructions on hinge label. Unplug the unit.