Whirlpool WOC97ES0ES 安装指导

下载
页码 16
2
BUILT-IN MICROWAVE/OVEN COMBINATION SAFETY
You can be killed or seriously injured if you don't immediately 
 
You
 
can be killed or seriously injured if you don't follow 
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety 
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.
Tools Needed
 
Phillips screwdriver
 
Measuring tape
 
Drill (for wall cabinet installations)
 
1" (2.5 cm) drill bit (for wall cabinet installations)
 
Level
 
Flat-blade screwdriver
Parts Needed
 
UL-listed or CSA-approved conduit connector
 
UL-listed wire connectors
 
Warming Drawer Deflector Kit (for ovens installed above  
a warming drawer)
 
 Order Part Number W10489569A for stainless steel 30" 
(76.2 cm) kit
 
 To order, see the “Assistance or Service” section                 
of the Use and Care Guide.
 
Flush Installation Kit (for Combo installed at flush 
installation)
 
 Order Part Number W10752693A for stainless steel 30" 
(76.2 cm) kit
 
 To order, see the “Assistance or Service” section                
of the Use and Care Guide:
Parts Supplied
#8-14 x 1" screws (4)
Bottom vent
#8-18 x ³⁄
8
" screws – bottom vent (2)
Check local codes. Check existing electrical supply.              
See “Electrical Requirements.”
It is recommended that all electrical connections be made       
by a licensed, qualified electrical installer.
Built-In Microwave/Oven Combination 
Location Requirements
IMPORTANT: Observe all governing codes and ordinances. 
 
Cabinet opening dimensions that are shown must be used. 
Given dimensions provide minimum clearance with oven.
 
Recessed installation area must provide complete 
enclosure around the recessed portion of the oven.
 
Grounded electrical supply is required. See “Electrical 
Requirements” section.