Whirlpool WOC97ES0ES 安装指导

To properly install your oven, you must determine the type 

of electrical connection you will be using and follow the 

instructions provided for it here.

■

 

Oven must be connected to the proper electrical voltage, 

amperage, and frequency as specified on the model/serial/ 

rating plate. See the following illustration.

■

 

Models rated from 7.3 to 9.6 kW at 240 volts (5.4 to  

7.4 kW at 208 volts) require a separate 40-amp circuit. 

Models rated at 4.8 kW and below at 240 volts (3.6 kW  

and below at 208 volts) require a separate 30-amp circuit.

■

 

A circuit breaker is recommended.

■

 

Connect directly to the fused disconnect (or circuit breaker 

box) through flexible, armored or nonmetallic sheathed, 

copper cable (with grounding wire). See “Make Electrical 

Connection” section.

1.   Decide on the final location for the oven. Locate existing  

wiring to avoid drilling into or severing wiring during  

installation.

2.   To avoid floor damage, set the oven onto cardboard prior 

to installation. Do not use handle or any portion of the front 

frame for lifting.

3.   Remember to remove bottom vent from the foam packing  

on top of oven.

4.  Remove the shipping materials and tape from the oven.
5.   Remove the hardware package from inside the bag  

containing literature.

6.   Remove and set aside racks and other parts from inside  

the oven.

7.   Move oven and cardboard close to the oven’s final location.

IMPORTANT: Use two hands to remove oven door.
1.   Prior to removing the oven door, prepare a surface where 

you will place it. This surface should be flat and covered with 

a soft blanket, or use the corner posts from your packaging 

material.

2.  Open the oven door.
3.   Locate the oven door hinge locks in both corners of the 

oven door, and then rotate the hinge locks toward the oven 

door to the unlocked position. If the door hinge lock is not 

rotated fully (see illustration B), the door will not remove 

properly.

■

Flexible conduit from the oven should be connected           

 

directly to the junction box.

■

 

Do not cut the conduit. The length of conduit provided         

is for serviceability of the oven.

■

 

A UL-listed or CSA-approved conduit connector must be 

provided.

■

 

If the house has aluminum wiring, follow the procedure 

below:

1.  Connect a section of solid copper wire to the ends 

of the flexible conduit leads.

2.  Connect the aluminum wiring to the added section  

of copper wire using special connectors and/or tools 

designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer’s  

recommended procedure. Aluminum/copper connection 

must conform with local codes and industry-accepted  

wiring practices.

For power requirements, refer to the following table:

120/240

32

30

8.0 kW

120/208

30

28

6.6 kW

Amperage values noted above are for information purposes  

only: The units are rated in watts.