Whirlpool WDT780SAEM 业主指南

The TargetClean™ wash area is located at 
the back of the lower level rack.

NOTE: You must select the TargetClean™ 
wash option to use this feature. Make sure 
items do not interfere with the water feed 
tube, spray arms, or TargetClean™ spray 
jets.

■

Load pans, casserole dishes, etc. in the 
back of the lower dish rack with the soiled surfaces facing the 
TargetClean™ spray jets. 

■

Only one row of items may face the TargetClean™ spray jets. 
Stacking, overlapping or nesting items will keep the 
TargetClean™ spray jets from contacting all of the surfaces.

The ANYWARE™ PLUS silverware basket can be hung on the 
door, the bottom rack, or placed inside the bottom rack. 

To unlock, grasp the front panel, pull up and rotate 90° as shown. 
Make sure the front panel is up all the way before rotating

. To 

unlock and rotate the front panel, grasp the front panel as shown 
and pull it up and out. 

NOTE: Be sure the front panel of the silverware basket is 
completely locked into place before pulling out the bottom rack 
and before closing the dishwasher door.

To remove the basket from the door
1. Grasp the silverware basket by the handle. Slide it toward the 

top of the door.

2. Lift the basket off the holding buttons.

To replace the basket in the door
1. Set the silverware basket on the holding buttons.

2. Slide the basket toward the bottom of the door until is locks 

into place.

Fold down the extra shelf on the left-
hand or right-hand side of the top rack 
to hold additional cups, stemware or 
long items such as utensils and 
spatulas.

The row of tines on the left-
hand and right-hand sides 
of the upper or in the back 
of lower rack can be 
adjusted to make room for a 
variety of dishes.

To adjust the fold-down 
tines
1. Grasp the tip of the tine 

that is in the tine holder.

2. Gently push the tine out 

of the holder.

3. Lay the tines down, toward the center of the rack.

The light item clips hold lightweight plastic items 
such as cups, lids, or bowls in place during 
washing.

To move a clip
1. Pull the clip up and off the tine.

2. Reposition the clip on another tine.

To follow progress of 
your dishwasher cycle.
NOTE: Indicators shown 
are not available on all 
models.

The Clean indicator glows when a cycle is finished. 

If you select the Sani Rinse option, when the cycle is finished, the “Sanitized” indicator 
glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the 
end of the cycle. This can happen if the cycle is interrupted, or water could not be 
heated to required temperature. The light goes off when you open and close door or 
press CANCEL.

      Back of
dishwasher

PUSH