Frigidaire FFES3015LS 安装指导

10

Installation With Backguard
The cutout depth of (21 3/4" (55.2 cm) Min., 22 1/8" 
(56.2cm) Max.) needs to be increased to 24" (61 cm) 
when installing a backguard.
Installation With End Panel
A End Panel kit can be ordered through a Service 
Center.
Installation With Side Panels
A Side Panels kit can be ordered through a Service 
Center. Note: Install cabinet doors 32" (81.3 cm) min. 
apart so as not to interfere with range door opening.

Refer to the Use and Care Manual packaged with 

the range for operating instructions and for care and 

cleaning of your range.

 Do not touch the elements. They may 

be hot enough to cause burns.

Remove all packaging from the oven before testing.

Turn on each of the four surface elements and check to 

see that they heat. Check the surface element indicator 

light(s), if equipped.

Level the range and set cooktop height before 
installation in the cut-out opening.
1.  Install an oven rack in the center of the oven.
2.  Place a level on the rack. Take 2 readings with the 

level placed diagonally in one direction and then the 
other. Level the range, if necessary, by adjusting the 
4 leg levelers with a wrench (see Figure12).

3.  Taking care to not damage the countertop, slide 

range into cut-out opening and double check for 
levelness.

The oven is equipped with an electronic oven control. Each 

of the functions has been factory checked before shipping. 

However, it is suggested that you verify the operation of 

the electronic oven controls once more. Refer to the Use 

and Care Manual for operation. Follow the instructions for 

the Clock, Timer, Bake, Broil, Convection (some models) 

and Clean functions.

Bake–After setting the oven to 350°F (177°C) for 

baking, the lower element in the oven should become 

red.

Broil–When the oven is set to BROIL, the upper element 

in the oven should become red.

Clean–When the oven is set for a self-cleaning cycle, the 

upper element should become red during the preheat 

portion of the cycle. After reaching the self-cleaning 

temperature, the lower element will become red.

Convection (some models)–When the oven is set to 

CONV. BAKE/ROAST at 350°F (177°C), both elements 

cycle on and off alternately and the convection fan will 

turn. The convection fan will stop turning when the oven 

door is opened during convection baking or roasting.

Warmer Drawer (some models)–Set the control knob 

to HI and check to see the drawer is heating.

Make sure all controls are left in the OFF position.

The serial plate is located on the oven front frame behind 
the oven door (some models) or behind the drawer 
(some models).

When ordering parts for or making inquiries about your 
range, always be sure to include the model and serial 
numbers and a lot number or letter from the serial plate 
on your range.

Read the Before you call list and operating instructions 
in your Use and Care Manual. It may save you time and 
expense. The list includes common occurrences that are 
not the result of defective workmanship or materials in 
this appliance.

Refer to the warranty and service information in your Use 
and Care Manual for our phone number and address. 
Please call or write if you have inquiries about your range 
product and/or need to order parts.