Frigidaire FFES3015LS 安装指导

11

B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8" 
pilot hole where screws are to be located. If bracket is to 
be mounted to the wall, drill pilot hole at an approximate 
20° downward angle. If bracket is to be mounted to 
masonry or ceramic floors, drill a 3/16" pilot hole 1-3/4" 
deep. The screws provided may be used in wood or 
concrete material. Use a 5/16" nut-driver or flat head 
screwdriver to secure the bracket in place.

C. Level and position the range - Slide range to 
its final position. Insert the range leveling leg in the 
anti-tip bracket. Visually verify if the anti-tip bracket is 
engaged. Lower the range by adjusting the 4 leveling legs 
alternatively until the range is level. Check if the range 
is level by placing a spirit level on the oven rack. Take 2 
readings with the spirit level placed diagonally; take a 
reading in one direction and then in the other direction. 
Level the range if necessary by adjusting the leveling legs.

Range side

 To reduce the risk of tipping of the 

range, the range must be secured to the floor by the 
properly installed anti-tip bracket and screws packed with 
the range. Failure to install the anti-tip bracket will allow 
the range to tip over if excessive weight is placed on an 
open door or if child climbs upon it. Serious injury might 
result from spilled hot liquids or from the range itself.

If range is ever moved to a different location, the anti-tip 
bracket must also be moved and installed with the range.

Instructions are provided for installation in wood or 
cement floor. When fastening to floor, be sure that screws 
do not penetrate electrical wiring or plumbing.

A. Locate the Bracket Using the Template - Locate the 
bracket position (right or left side) by placing the template 
symmetrically to the center of the final range position. 
Mark the location of the screw holes, shown on template.