AMT Datasouth 4000 用户手册
User's Guide 83
Appendix C: PRINTER STATUS
The printer has built-in monitors for the status. If the printer is equipped with the LCD
module the printer status can be displayed on it. The display on LCD is just for models
FM4602 and FM4603.
module the printer status can be displayed on it. The display on LCD is just for models
FM4602 and FM4603.
LCD display
Blinking LED
Description
PAUSE
READY
The printer is in a pause state. Press
PAUSE or CANCEL to return to normal
state.
PAUSE or CANCEL to return to normal
state.
MEDIA OUT
MEDIA
READY
The media is uninstalled or used up. Load
new media to the printer.
new media to the printer.
RIBBON OUT
RIBBON
READY
The ribbon is uninstalled or end-of-ribbon
occurred. Load new ribbon to the printer.
If using Direct Thermal media verify that
Switch 1 is off.
occurred. Load new ribbon to the printer.
If using Direct Thermal media verify that
Switch 1 is off.
SERIAL IO ERROR
READY
The format or baud rate of the RS-232
communication may be incorrect. Verify
host and switches 6 to 8.
communication may be incorrect. Verify
host and switches 6 to 8.
CUTTER FAILED
READY
The cutter can not cut off the media, check
the media and cutter.
the media and cutter.
MEMORY FULL
READY
The printer buffer is full. Possibly caused
by the loaded soft fonts, graphics or forms.
Check the format of these data.
by the loaded soft fonts, graphics or forms.
Check the format of these data.
HEAD OPEN
READY
The printhead latch is not closed. To print
the label the head latch must be closed.
the label the head latch must be closed.
P. SENSOR O.R.
READY
The media sensor is out of range during
calibration. Make sure the media is
installed and the label sensor is put under
the media.
calibration. Make sure the media is
installed and the label sensor is put under
the media.