Roland RMP-12 用户手册
17
Getting Ready to Play
Once the connections have been completed, turn on
power to your audio devices in the order specified.
Turning on devices in the wrong order may cause
malfunction and/or damage to speakers and other devices.
1.
Turn the [PHONES VOLUME] knob to the minimum
level.
2.
Switch on the power to the device that’s
connected to the MIX IN jack.
3.
Press the [POWER] button to turn on the power.
Always make sure to have the volume level turned
down before switching on power. Even with the
volume all the way down, you may still hear some
sound when the power is switched on, but this is
normal, and does not indicate a malfunction.
This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required
before the unit will operate normally.
4.
While striking the head, gradually turn the [PHONES
VOLUME] knob to adjust the volume level.
If an Amp is Connected to the OUTPUT Jack
1.
Turn down the volume control on each of the
devices in your system.
2.
Switch on the power to the device that’s
connected to the MIX IN jack.
3.
Press the [POWER] button to turn on the power.
4.
Turn on the connected amp system, and adjust the
volume to the desired level.
Before switching off the power, lower the volume on each of the
devices in your system and then turn off the devices in the
reverse order to which they were switched on.
devices in your system and then turn off the devices in the
reverse order to which they were switched on.
To prevent the batteries from running down unnecessarily, the
Auto Power-off function will automatically turn off the power if
the pad has not been struck or any other operation performed for
ten minutes after the most recent button operation.
Auto Power-off function will automatically turn off the power if
the pad has not been struck or any other operation performed for
ten minutes after the most recent button operation.
If the metronome is on, the power will automatically turn off if the
pad has not been struck or any other operation performed for
twenty minutes after the most recent button operation.
pad has not been struck or any other operation performed for
twenty minutes after the most recent button operation.
Turning the Power On and Off
When Turning Off the Power
Auto Power-off
RMP-12_e.book 17 ページ ２００８年７月１１日 金曜日 午前９時４５分